Adapting ECU to Throttle Valve

Adapting ECU to ThrottleValve

Make SureThat: Battery Voltage>11.5V

No Fault Codes stored in EngineECU Coolant Temp 5 to 115 ℃

ThrottleValve at Idle Position Ignition on,engine not running Procedure:

Ignition on,engine not running Select

(01 EngineElectronics)

Enter '098' or '060' on drive by wiresystems

 Press(OK)

The values will now change,Value 4 the lower right will change from ADPRUN to ADP.OK.

(Note:If No Values are shown you are using the wrong channel number) This shows the Throttle Body adaptation is being done.

Press (BACK) and (BACK) again to Exit from Module Switch off ignition for at least 15 seconds to store values

On Older Cars

Make SureThat:Battery Voltage>11.5V

No Fault Codes stored in Engine ECU Coolant Temp 5 to 115 ℃

Throttle Valve at Idle Position

Ignition on,engine Running Procedure:

Ignition on , engine Running Select

(01 EngineElectronics)

Enter '001'， Press (OK)

 Let engine Idle for at least 30 seconds