You have no items in your shopping cart.
Products
- P1639 Mahindra Genio (BS III & BS IV) - State of overrun detection (0: no overrun; 1:overrun).
- P0340 Mahindra Genio (BS III & BSIV)- No camshaft signal.
- P0341 Mahindra Genio (BS III & BS IV) - Wrong camshaft signal.
- P0403 Mahindra Genio (BS III & BSIV)- Openload.
- P1644 Mahindra Genio (BS III & BS IV) - Voltage above upper limit.
- P1646 Mahindra Genio (BS III & BS IV) - Error is sensor supply Monitor 2.
- P1648 Mahindra Genio (BS III & BS IV) - Error is sensor supply Monitor 3.
- P1650 Mahindra Genio (BS III & BS IV) - Short circuit to battery.
- P1651 Mahindra Genio (BS III & BS IV) - Short circuit to ground.
- P1652 Mahindra Genio (BS III & BS IV) - Open load.
- P1653 Mahindra Genio (BS III & BS IV) - Over temperature in the power stage of the ECU.
- P1654 Mahindra Genio (BS III & BS IV) - Short circuit to battery.
- P1655 Mahindra Genio (BS III & BS IV) - Short circuit to ground.
- P1656 Mahindra Genio (BS III & BS IV) - Open load.
- P1657 Mahindra Genio (BS III & BS IV) Over temperature in the power stage of the ECU.
- P1670 Mahindra Genio (BS III & BS IV) - Shutoff request of the injection cutoff.
- P1737 Mahindra Genio (BS III & BS IV) - IMA not flashed for cylinder 1.
- P1738 Mahindra Genio (BS III & BS IV) - IMA not flashed for cylinder 2.
- P1739 Mahindra Genio (BS III & BS IV) - IMA not flashed for cylinder 3.
- P1740 Mahindra Genio (BS III & BS IV) - IMA not flashed for cylinder 4.
- P1792 Mahindra Genio (BS III & BS IV) - Brake signals not plausible.
- P1832 Mahindra Genio (BS III & BS IV) - Immobilizer Authentication Failed
- P1911 Mahindra Genio (BS III & BS IV) - Error in plausibility of the Accelerator pedal voltages.
- P0404 Mahindra Genio (BS III & BSIV)- Over temperature in the power stage of the ECU.
- P1913 Mahindra Genio (BS III & BS IV) - Error in the plausibility of the injection quantities.
- P0405 Mahindra Genio (BS III & BSIV)- Short circuit to ground.
- P0406 Mahindra Genio (BS III & BSIV)- Short circuit to battery.
- P0480 Mahindra Genio (BS III & BSIV) - Open load.
- P1914 Mahindra Genio (BS III & BS IV) - Error in the plausibility of the start of energising angles.
- P0501 Mahindra Genio (BS III & BSIV)- Vehicle speed not plausible with injection mass and engine speed.
- P1915 Mahindra Genio (BS III & BS IV) - Error in the plausibility check of the ZFC energizing times
- P1916 Mahindra Genio (BS III & BS IV) - Error in the plausibility of PoI2 efficiency.
- P0503 Mahindra Genio (BS III & BSIV)- Exceeding of the maximum vehicle speed.
- P0562 Mahindra Genio (BS III & BSIV)- Battery voltage below lower limit.
- P1917 Mahindra Genio (BS III & BS IV) - Error in the PoI2 shut-off.
- P0563 Mahindra Genio (BS III & BSIV)- Battery voltage above upper limit.
- P1918 Mahindra Genio (BS III & BS IV) - Error due to injection quantity correction.
- P0607 Mahindra Genio (BS III & BSIV) - Over temperature in the power stage of the ECU.
- P0691 Mahindra Genio (BS III & BSIV) - Short circuit to ground.
- P1919 Mahindra Genio (BS III & BS IV) - Plausibility error in rail pressure monitoring.
- P0692 Mahindra Genio (BS III & BSIV) - Short circuit to battery.
- P1922 Mahindra Genio (BS III & BS IV) - Visibility of software resets 2 in DSM
- P0704 Mahindra Genio (BS III & BSIV)- Clutch signal is not plausible Clutch Switch.
- P1103 Mahindra Genio (BS III & BSIV)- Plausibility check of offset drift of airmass,ratio is lower than threshold low.
- P2269 Mahindra Genio (BS III & BS IV) - Water presence in fuel error.
- P1104 Mahindra Genio (BS III & BSIV)- Plausibility check of offset drift of airmass,ratio is higher than threshold high.
- P1109 Mahindra Genio (BS III & BSIV)- Correction factor 0 monitoring of the drift compensation function of AFS.
- P1194 Mahindra Genio (BS III & BSIV)- Maximum negative rail pressure deviation with metering unit on lower limit is exceeded.
- P2558 Mahindra Genio (BS III & BS IV) - Minimum Temperature not reached within time limit.
- P1120 Mahindra Genio (BS III & BSIV)- Synchronisation error for APP1 and APP2.
