You have no items in your shopping cart.
Products
- P0480 MAHINDRA MAXXIMO (BS‐III )- Fan control open load error.
- P562 MAHINDRA MAXXIMO (BS‐III )- Battery voltage below lower limit.
- P563 MAHINDRA MAXXIMO (BS‐III )- Battery voltage above upper limit.
- P0607 MAHINDRA MAXXIMO (BS‐III )- Fan control over temperature error.
- P0691 MAHINDRA MAXXIMO (BS‐III )- Fan control Short circuit to ground.
- P0692 MAHINDRA MAXXIMO (BS‐III )- Fan control Short circuit to battery.
- P1126 MAHINDRA MAXXIMO (BS‐III) - Minimum temperature or temperature raise no reached within.
- P1183 MAHINDRA MAXXIMO (BS‐III) - Fuel temp above critical limit
- P1190 MAHINDRA MAXXIMO (BS‐III )- Rail pressure sensor raw value is above maximum offset.
- P1191 MAHINDRA MAXXIMO (BS‐III )- Rail pressure sensor raw value is below minimum offset.
- P1210 MAHINDRA MAXXIMO (BS‐III) - Chip internal reset/clock loss/ under voltage inside the ECU.
- P1259 MAHINDRA MAXXIMO (BS‐III )- Open load fault in the pressure control valve.
- P1260 MAHINDRA MAXXIMO (BS‐III) - Over temperature of pressure control valve power stage.
- P1340 MAHINDRA MAXXIMO (BS‐III) Camshaft failure offset between crankshaft and camshaft.
- P1492 MAHINDRA MAXXIMO (BS‐III )- maximum positive deviation of rail pressure exceeded.
- P1493 MAHINDRA MAXXIMO (BS‐III )- maximum positive deviation of rail pressure exceeded concerning set value PCV.
- P1494 MAHINDRA MAXXIMO (BS‐III )- maximum negative rail pressure deviation with closed pressure control valve exceeded.
- P1495 MAHINDRA MAXXIMO (BS‐III )- minimum rail pressure exceeded.
- P1496 MAHINDRA MAXXIMO (BS‐III )- maximum rail pressure exceeded.
- P1503 MAHINDRA MAXXIMO (BS‐III)- Coolant temp above critical limit (Engine over heating)
- P1608 MAHINDRA MAXXIMO (BS‐III) - coolant temperature output (on dash panel): Short circuit to battery.
- P1609 MAHINDRA MAXXIMO (BS‐III) - coolant temperature output (on dash panel): Short circuit to ground.
- P1633 MAHINDRA MAXXIMO (BS‐IV) - Ambient air temperature sensor voltage above upper limit
- P1634 MAHINDRA MAXXIMO (BS‐IV) - Ambient air temperature sensor voltage below lower limit.
- P1639 MAHINDRA MAXXIMO (BS‐III) - State of overrun detection.
- P1640 MAHINDRA MAXXIMO (BS‐III )- Power stage of Pre supply pump excess Temperature.
- P1650 MAHINDRA MAXXIMO (BS‐IV )- MIL Power stage short circuit to battery.
- P1651 MAHINDRA MAXXIMO (BS‐IV )- MIL Power stage short circuit to ground.
- P1652 MAHINDRA MAXXIMO (BS‐IV )- MIL Power stage no load.
- P1653 MAHINDRA MAXXIMO (BS‐IV )- MIL Power stage excess temperature.
- P1654 MAHINDRA MAXXIMO (BS‐III )- System lamp short circuit to battery.
- P1655 MAHINDRA MAXXIMO (BS‐III )- System lamp short circuit to ground.
- P1656 MAHINDRA MAXXIMO (BS‐III )- System lamp no load.
- P1657 MAHINDRA MAXXIMO (BS‐III )- System lamp excess temperature.
- P1658 MAHINDRA MAXXIMO (BS‐III)- Ignition key status wrong
- P1670 MAHINDRA MAXXIMO (BS‐III) - Shut off request of injection cut off.
- P1737 MAHINDRA MAXXIMO (BS‐III) - IMA not flashed for cylinder 1.
- P1739 MAHINDRA MAXXIMO (BS‐III) - IMA not flashed for cylinder 2.
- P1791 MAHINDRA MAXXIMO (BS‐III )- Brake signal received is defective.
- P1792 MAHINDRA MAXXIMO (BS‐III )- Brake signal not plausible.
- P1900 MAHINDRA MAXXIMO (BS‐III) - Diagnostic fault check to report the NTP error in ADC monitoring
- P1901 MAHINDRA MAXXIMO (BS‐III) - Error during SOP test; uncertain cause (defective injector or shut- off path).
- P1902 MAHINDRA MAXXIMO (BS‐III) - Diagnostic fault check to report the ADC test error.
- P1903 MAHINDRA MAXXIMO (BS‐III) - Diagnostic fault check to report the error in Voltage ratio in ADC monitoring.
- P1904 MAHINDRA MAXXIMO (BS‐III) - Diagnostic fault check to report errors in query-/response- communication
- P1905 MAHINDRA MAXXIMO (BS‐III) - interrupted SPI communication
- P1906 MAHINDRA MAXXIMO (BS‐III) - Diagnostic fault check to report multiple error while checking the complete ROM-memory
- P1907 MAHINDRA MAXXIMO (BS‐III) - Loss of synchronization sending bytes to the MM from CPU.
- P1908 MAHINDRA MAXXIMO (BS‐III) - Error trying to set MM Response time.
- P1909 MAHINDRA MAXXIMO (BS‐III) - Too many SPI errors during MoCSOP execution.
